超临界压力CO2在水平圆管内流动传热数值分析

采用SST k-w低雷诺数湍流模型对加热条件下超临界压力CO2在内径di=22.14 mm,加热长度Lh=2440 mm水平圆管内三维稳态流动与传热特性进行了数值计算.通过超临界CO2在水平圆管内的流动传热实验数据验证了数值模型的可靠性和准确性.首先,研究了超临界压力CO2在水平圆管内的流动传热特点,基于超临界CO2在类临界温度Tpc处发生类液-类气“相变”的假设,揭示了水平圆管顶母线和底母线区域不同的流动传热行为.然后,分析了热流密度qw和质量流速G对水平圆管内超临界压力CO2流动换热的影响,通过获取流体域内的物性分布、速度分布和湍流分布等详细信息,重点解释了不同热流密度qw和质量流速G下顶母线内壁温度Tw,i分布产生差异的传热机理,分析结果确定了类气膜厚度d、类气膜性质、轴向速度u和湍动能k是影响顶母线壁温分布差异的主要因素.研究结果可以为超临界压力CO2换热装置的优化设计和安全运行提供理论指导.     

Switching of heating and cooling modes using thermal radiation films

We study emissivity (ε)-dependent radiative heat transfer phenomena in remote and contact configurations. To demonstrate the emissivity-dependent radiative heating mode in a remote configuration, we fabricated miniature greenhouses covered with low (0.34)- and high-ε (0.86) polyethylene films and monitored temperatures on the floors, insides, and covers of the greenhouses during 24 h. The high-ε greenhouse yielded a 9-°C increase in floor temperature relative to the low-ε greenhouse at a one-sun solar irradiance because the high-ε film effectively trapped floor radiation. In contrast, the cover temperature remained lower in the high-ε greenhouse due to intensified radiation released from the high-ε film. This self-cooling effect was more evident when an emissive film was in physical contact with an object. While bare copper heated up to 55 °C, a high-ε film coated copper substrate was kept cooler by 4 and 2 °C compared with the bare and low-ε film coated copper samples, respectively.     

高效液相色谱-荧光检测器法测定2-噁唑烷酮的含量

建立一种利用高效液相色谱结合荧光检测器准确测定2-噁唑烷酮含量的方法。样品中的2-噁唑烷酮和占吨氢醇在60℃的条件下衍生70 min后,直接进样分析。采用月旭XB-C18色谱柱,流动相为0.02 mol/L乙酸钠水溶液和乙腈,检测器波长为λex=213 nm,λem=308 nm,流速1.0 mL/min,柱温35℃的条件下。2-噁唑烷酮浓度在0.5~50.0mg/mL时,线性关系良好(R2=0.9995),检测限和定量限分别为0.005 mg/L、0.016 mg/L。该方法准确、灵敏、快速,适用于2-噁唑烷酮含量的检测。     

Caesium carbonate supported on hydroxyapatite‐encapsulated Ni0.5Zn0.5Fe2O4 nanocrystallites as a novel magnetically basic catalyst for the one‐pot synthesis of pyrazolo[1,2‐b]phthalazine‐5,10‐diones

A novel nanomagnetic basic catalyst of caesium carbonate supported on hydroxyapatite‐coated Ni_0.5Zn_0.5Fe₂O₄ magnetic nanoparticles (Ni_0.5Zn_0.5Fe₂O₄@HAP‐Cs₂CO₃) was prepared. This new catalyst was fully characterized using Fourier transform infrared spectroscopy, transmission and scanning electron microscopy, X‐ray diffraction and vibrating sample magnetometry techniques, and then the catalytic activity of this catalyst was investigated in the synthesis of 1H‐pyrazolo[1,2‐b]phthalazine‐5,10‐dione derivatives. Also, Ni_0.5Zn_0.5Fe₂O₄@HAP‐Cs₂CO₃ could be reused at least five times without significant loss of activity and could be recovered easily by applying an external magnet. Thus, the developed nanomagnetic catalyst is potentially useful for the green and economic production of organic compounds. Copyright © 2015 John Wiley & Sons, Ltd.     

Sulfono‐γ‐AApeptides as a New Class of Nonnatural Helical Foldamer

Foldamers offer an attractive opportunity for the design of novel molecules that mimic the structures and functions of proteins and enzymes including biocatalysis and biomolecular recognition. Herein we report a new class of nonnatural helical sulfono‐γ‐AApeptide foldamers of varying lengths. The crystal structure of the sulfono‐γ‐AApeptide monomer S6 illustrates the intrinsic folding propensity of sulfono‐γ‐AApeptides, which likely originates from the bulkiness of tertiary sulfonamide moiety. The two‐dimensional solution NMR spectroscopy data for the longest sequence S1 demonstrates a 10/16 right‐handed helical structure. Optical analysis using circular dichroism further supports well‐ defined helical conformation of sulfono‐γ‐AApeptides in solution containing as few as five building blocks. Future development of sulfono‐γ‐AApeptides may lead to new foldamers with discrete functions, enabling expanded application in chemical biology and biomedical sciences.     

Lanthanum trilactate: Vibrational spectroscopic study − infrared/Raman spectroscopy

In this study lanthanum trilactate was prepared by neutralization reaction of lactic acid and lanthanum oxide, purified and identified by X-ray powder diffraction. Infrared spectra (Mid-IR region 4000–650 cm⁻¹) and Raman spectra (Stokes region 4000–100 cm⁻¹) of the high quality crystalline samples have been recorded and presented for the first time. For comparison DFT calculations were performed using Gaussian 09 D.01 and agreement between predicted and measured spectral data has been achieved. Acquired information can be utilized for substance identification for example in various industrial applications or in biological systems.     

A One‐Pot Synthesis of N‐Aryl‐2‐Oxazolidinones and Cyclic Urethanes by the Lewis Base Catalyzed Fixation of Carbon Dioxide into Anilines and Bromoalkanes

The multicomponent assembly of pharmaceutically relevant N‐aryl‐oxazolidinones through the direct insertion of carbon dioxide into readily available anilines and dibromoalkanes is described. The addition of catalytic amounts of an organosuperbase such as Barton's base enables this transformation to proceed with high yields and exquisite substrate functional‐group tolerance under ambient CO₂ pressure and mild temperature. This report also provides the first proof‐of‐principle for the single‐operation synthesis of elusive seven‐membered ring cyclic urethanes.     

Synthesis of thermally stable aromatic poly(spiroorthocarbonate)s having a Cardo or bent structure

Novel poly(spiroorthocarbonate)s [poly(SOC)]s having a Cardo or bent structure were synthesized by polycondensation of several bis‐catechols having fluorene (BCFL), spirobisindane (BCSPI), or spirobischromane (BCSPC) in the structure with 2,2,6,6‐tetrachlorobenzo[1,2‐d:4,5‐d’]bis[1,3]dioxole (4ClBD). Synthesis of poly(SOC)s was confirmed by NMR and IR spectrometry. The poly(SOC)s obtained from BCFL or BCSPC were soluble in common organic solvents. The glass transition temperature of the poly(SOC)s was not detected by differential scanning calorimetry (DSC) in the range of 50–300 °C. The 10 wt % decomposition temperature of the poly(SOC)s was found to be above 400 °C. These results indicated the high thermal stability of the poly(SOC)s. Soluble poly(SOC)s could be possessed to form a film on a glass plate by the spin coat method. The obtained polymer films were 0.2 μm in thickness with 95% light transmission in the optical wavelength range. These results suggested that the Cardo or bent structure may block the packing of the main‐chain of the structure, which improves the solubility of the polymers, increases transparency, and enhances the thermal stability of SOCs. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2016 , 54, 1409‐1416     

Crosslinked poly(ethylene oxide) containing siloxanes fabricated through thiol‐ene photochemistry

Homogenous amphiphilic crosslinked polymer films comprising of poly(ethylene oxide) and polysiloxane were synthesized utilizing thiol‐ene “ click ” photochemistry. A systematic variation in polymer composition was Carried out to obtain high quality films with varied amount of siloxane and poly(ethylene oxide). These films showed improved gas separation performance with high gas permeabilities with good CO₂/N₂ selectivity. Furthermore, the resulting films were also tested for its biocompatibility, as a carrier media which allow human adult mesenchymal stem cells to retain their capacity for osteoblastic differentiation after transplantation. The obtained crosslinked films were characterized using differential scanning calorimetry, dynamic mechanical analysis, thermogravimetric analysis, FTIR, Raman‐IR , and small angle X‐ray scattering. The synthesis ease and commercial availability of the starting materials suggests that these new crosslinked polymer networks could find applications in wide range of applications. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2015 , 53, 1548–1557     

水热法制备二氧化钛微球的形貌控制及机理研究

以钛粉、Na OH和H2O2为原料,采用水热法成功制备出二氧化钛微球。利用X-射线粉末衍射仪(XRD)、扫描电子显微镜(SEM)和场发射扫描电镜(FESEM)对产物的结构、形貌和尺度进行了表征。结果表明,产物为金红石型Ti O2,微球的直径约为1~2μm,微球由许多纳米管组成。根据实验结果,讨论了二氧化钛纳米管的生长机理,初步研究了双氧水用量,水热温度以及煅烧温度等对产物形貌形成的影响。